Agile™ and Answer Biometric Lock Set - Programming and Reset Instructions
Your new Agile series gun cabinet includes a customizable, electronic biometric lock with a key override and a USB-C power port.
Factory (Default) Lock Settings:
Manager Code: 1-2-3-4-5-6
User One: 1-1-1-1
User Two: 2-2-2-2
Keypad Sound: On
Keypad Backlight: On
LED Lights:
Left LED: Red (Low Battery Warning Light)
Right LED: Yellow (Input Registered) / Green (Correct Code Received)
NOTE: Never store or place your override keys inside the cabinet. Always make programming changes with the door open, and test the new codes/fingerprints before closing or locking the door.
We only recommend installing brand new (directly from the store), brand name (Energizer or Duracell), alkaline batteries. Do not use lithium or rechargeable batteries.
To reprogram the manager code:
1. Remove the round, black plastic cover on the inner door panel to reveal the red reset button.
2. Press and release the red reset button.
3. Enter a new manager code, between 3 and 12 digits long.
4. Press and release the red reset button to save the code.
5. Test the new code to confirm.
To reprogram the user codes:
1. Remove the round, black plastic cover on the inner door panel to reveal the red reset button.
2. Select the code you'd like to reprogram. Press 1 for code number one or 2 for code number two, then immediately press the red reset button.
3. Enter a new user code, between 3 and 12 digits long.
4. Press and release the red reset button to save the code.
5. Test the new code to confirm.
6. Follow steps 1-5 to reprogram the other user code.
To program fingerprints:
1. Remove the round, black plastic cover on the inner door panel to reveal the red reset button.
2. Press the number 3 keypad button, then immediately press and release the red reset button.
3. Press one fingerprint against the scanner until you hear a small beep.
4. Reposition your finger and repeat step 3, until you hear a long beep and the green LED flashes.
Note: If the yellow LED flashes three times, then the fingerprint was not saved and you’ll need to repeat the process.
Turning the fingerprint scanner ON/OFF:
In the standby state, press the 6 button twice, then press and release the red reset button to disable or enable the fingerprint scanner.
Turning the Keypad Sound ON/OFF:
In the standby state, hold down the 4 button to enable or disable sound.
Turning the Keypad Backlight ON/OFF:
In the standby state, hold down the 6 button to enable or disable the keypad’s backlight.
Factory reset:
To revert to the default settings, hold the red reset button for 5 seconds, until you hear a long beep.
Lock Out Mode:
If you enter incorrect codes or fingerprints five times in a row, then the keypad will go into lock-out mode for 60 seconds.
During lock-out mode, the keypad will beep every second. You will need to wait until the keypad stops beeping before you can try again.
USB-C Power Port:
If the battery is dead or weak, then you can power the keypad with a USB-C power cord and the power port on the bottom, right side of the keypad.
We only recommend installing brand new (directly from the store), brand name (Energizer or Duracell), alkaline batteries. Do not use lithium or rechargeable batteries.
Key Override:
The key hole is covered by the Agile name plate on the door. Remove the nameplate with a Philips head screwdriver to access the keyhole
To view and download the PDF version, please use the link below: