Fast Box - How To Replace Reset Button

Overview: This guide will explain how to replace the Passcode Reset Button on the Fast Box™ 40 and 47.

Tools Needed: The following tools are required to complete this task (not included):

• Phillips-Head Screwdriver (recommend using hand tools rather than a drill to avoid stripping screws)
• Flat-Head Screwdriver

Step 1:  Locate the existing Reset Button 

• Your model may or may not have the red cap, depending on when it was made

  

Step 2:  Remove the lock washer and cap (if applicable) and press the button housing through until fully recessed

Step 3: Set the cap and washer aside in a safe place.

• Locate and remove the three (3) screws holding the door cover in place

  

• Set screws aside with the cap and washer

Step 4: Follow the cable from the button to locate the connector on the chipset – the connector is on the underside of the metal protection plate. (It helps to prop the cabinet up

• Inspect the connection to make sure the housing unit for the plug is not damaged

Step 5: Carefully unplug the current button.

• Inspect the chip again to ensure that both prongs are intact

Step 6: Carefully install the new cable.

• Be sure to weave the cable under the locking bar and insert the tip just enough to hold it in place
• Use a small flat-head screwdriver to gently press the connector into place

Note: DO NOT press too hard, or you risk breaking either piece

Step 7:  Inspect connection and cable placement

• Make sure the cable is under the lock rod and the tip is fully inserted (as shown below)

Step 8:  Reattach the Button to the back of the door

• Stick button housing unit through the hole from underneath side, holding in place

• Slide ring of cap over cap and screw in the lock washer until tight (on front side of door

Note: Once completed, follow the instructions for resetting your code as a test and ensure that the new button is working.